Ricoh C211 Service Manual page 616

4.
Adjusting The Exit Pawl Timing
-&-
[EJ
Purpose : To ensure that the exit pawl does not contact the master clamper.
Method : 1.
2.
3.
4.
5.
6.
7.
Remove the rear cover of the machine (6 screws).
Press the Image Shifting key to give a maximum white area at the paper
leading edge (image shift position set to "-2").
Stack 20 lb paper on the paper table.
Manually turn on the paper feed solenoid. Using a (lOmm) open end wrench,
gradually rotate the drum rotation shaft counterclockwise at a constant speed.
While rotating, make sure that the exit pawl [A] does not contact the master
clamper [B] and that the exit pawl [A] approaches the drum before the
leading edge of the printing paper exits.
If incorrect, loosen the hexagon nut [C] and screw [E] and adjust the exit
pawl position by turning the hexagon bolt [D].
Confirm this adjustment by repeating step 5 with the image position shifted
to both maximum forward and maximum backward directions.
5-76
Rev. 8/89