Ricoh C211 Service Manual page 604

6.
Adjusting The Master Eject Clamper Cam
Purpose :
Method :
[A]
I
,[01
I
\
d
[B]
0N=29 i 0.5mm OFF=less than 25mm
To position the master eject clamper cam [B] so that the master clamper
opens correctly during the master eject process and closes correctly for all
other processes.
1.
2.
3.
4.
5.
Remove the drum unit from the machine and open the master eject unit.
Remove the rear cover of the machine and turn on the master eject
clamper solenoid [A] as follows.
Turn on the solenoid [A] using the following procedure:
Turn on the power switch while pressing the Print Start key (Start key: SS830),
Stop key and Clear key on the operation panel.
Enter "()"in the memory display and "IO" in the copy counter.
Turn on the clamper solenoid [A] by pressing the Print Start key (Start key -
SS830).
Confirm that the distance between the bushing and the edge of the open-
ing cam [B] is 29 ~ 0.5 mm in the above condition.
If not, loosen the mounting screws [C] and adjust the position of the
clamper solenoid [A].
After adjustment, retighten the mounting screws [C].
Caution: Do not turn on the solenoid any longer than 10 seconds.
5-64