Ricoh C211 Service Manual page 122

2.8 ORIGINAL FEED ROLLERS / PULL-OUT ROLLERS
REPLACEMENT: VT2300/2500
b —J
\
[c]
1. Remove the original table (See page 5-2).
2. Replace the pull-out rollers [A] (1 snap ring, 1 pin).
3. Remove the E-rings at the both end of the original feed roller shaft [B].
4. Remove the ADF drive gear [C] and bushing [D].
5. Remove the original feed roller assembly [E].
6. Remove the stopper [F] (Allen screw).
7. Replace the original feed rollers [G].
NOTE: A one-way clutch is installed in the feed roller. Confirm that the roller
can rotate in the arrow direction as shown in the above illustration.
5-10