Ricoh C211 Service Manual page 656

9. Table of Defective Electrical Components: SS830
Component Condition Phenomenon
2nd Original Sensor
ON condition
When the main switch is turned on, the Jam
(Feeler is indicators "A" + ~ blink and reset is impos-
actuated)
sible.
OFF condition
The original is fed when the Start key is
(Feeler is not pressed, but the jam indicators "A" + ~
actuated) blink and the original leading edge
damages because the original transport
motor does not turn on.
Original Registra- ON condition After the master paper is ejected, the Jam
tion Sensor (Feeler is
indicators "A" + ~ blink.
actuated)
OFF condition The original is fed until the leading edge of
(Feeler is not the original goes 5 cm past the exposure
actuated)
glass, then jam indicators "A" + ~ blink.
Master Eject Switch ON condition
After the master is ejected and one sheet of
(Feeler is paper (trial print) is delivered, the jam un-
actuated) dicators "F" + 3$ blink and reset is impos-
sible.
OFF condition When the master is being ejected, the jam
(Feeler is not
indicators "F" + ~ blink.
actuated)
Pressure Plate Posi- ON condition The pressure plate does not go up. After
tion Switch (Feeler is one sheet of paper (trial print) is delivered,
actuated) the jam indicators "F" + & blink.
OFF condition
When the main switch is turned on, the
(Feeler is not pressure plate keeps moving up and down.
actuated)
After the master eject process is completed,
the jam indicators "F" + & blink.
Full Master Detect- ON condition
When the master eject box is full, the full
ing Switch (Feeler is
master indicators "F" + & do not blink.
actuated)
OFF condition
After master ejection is complete, the indi-
(Feeler is not
caters "F" + & blink.
actuated)
6-34