Dip Sw Table (Image Processing Board); Led Table - Ricoh C211 Service Manual

NOTE1 The shock wave from clamping might make a thin white line 60 mm
from the leading edge. This line is visible when the image is made
by photo mode. By turning on DPS 101-7, the reverse roller
solenoid ON timing is delayed to absorb the shock wave. However,
the above measure sometimes disturbs master registration (image
position on the master).
NOTE2 If the customer does not dispose of the ejected masters even
though full master is indicated (Turning off the main switch resets
full master condition), master eject jams or master eject belt might
slip off. Double master compression prevents the customer from
making a master when the master box is full. However, if this
switch is turned on, the master compression is performed twice for
every master made. This hastens parts wear and may cause
trouble.
NOTE3 The following skip number can be selected by setting DIP SW
103-5 and 103-6.
DPS103
5
6
If both DPS 103-4 (Mode Clear) and DPS 103-4/5 (Skip Paper
Feed Setting) are selected, Mode Clear mode is selected. (Skip
Feed is ignored.)

2.2 DIP SW TABLE (Image Processing Board)

No. DIP SW
1 DPS 400-1
2 DPS 400-1

2.3 LED TABLE

No. LED
1 LED 101
2 LED 102
3 LED 103
4 LED 104
C216
1 Sheet/ 1 Sheet/
1 Rotation 3 Rotation
OFF
OFF
Function
Turn off to access test pattern mode
Test Pattern
(Normal: ON)
Used to change dither matrix
Dither Pattern
(ON: 4 x 4, OFF: 6 x 6)
Function
Main Motor ON When the main motor turns on, LED lights
1st Paper Exit
When paper is detected, LED lights
SN Detection
2nd Paper Exit
When paper is detected, LED light
SN Detection
When ink is detected, LED lights
NOTE:
Ink Detection
4-3
1 Sheet/
5 Rotation
ON OFF
OFF ON
Remarks
Remarks
When the drum release lever is raised,
the drum connector is disconnected
and LED turns off.
1 Sheet/
8 Rotation
ON
ON
SM