Ricoh C211 Service Manual page 294

6.6 SYSTEM VERIFICATION AND DEFAULT CONFIGURATION
Now that the physical installation is complete, you are ready to start the
system verification .
1. Plug in all components of the system and turn them on in this order:
1.Computer
2. Priport
3. PCRIP-10
2. Look at the two lights located in the lower left corner below the product
label. The left hand light indicates "Power-on". It will stay on as long as
the PCRIP-10 is receiving power.
3. The right hand light indicates "Ready". It will come on for a few seconds
at Power-on and then go off for up to 60 seconds while the PCRIP-10
runs its internal diagnostics. If the Ready light comes back on and stays
on, the PCRIP-10 has passed its startup diagnostics and verified
communication with the Priport.
4. If the Ready light flashes quickly, the PCRIP-10 has not been able to
verify communication with the Priport.
A. First, check to see if the Priport is plugged in and turned on.
B. Next, check to see that the cable from the PCRIP-10 to the Priport is
securely seated in the ports at each end.
C. If the Ready light does not come on after these steps, turn off the
PCRIP-10 and then the Priport.
-
Check to see that the small "AMP" connector of the Interface Harness
is securely fastened to the connector on the Video Interface PCB.
-
Check to see that the I/O Ribbon Cable which connects the Video
Interface PCB to the image processing board inside the Priport is
securely fastened as well. Then, turn on the Priport and the PCRIP-10.
Watch the Ready light again to see if it comes on briefly, goes off for
approximately 30-60 seconds and then comes back on. If so, you are
ready to proceed. If not, contact your local service organization for help.
5. If the Ready light fails to come on at all, the PCRIP-10 has been
damaged, contact your local service organization for help.
6. Push the On Line button on the Priport Control Panel. The Priport must
be On Line for the Priport to accept input from the computer through the
VT2105 6-10 FSM