2. Paper leading edge jams under the second feed roller.
Does the upper second feed roller contact the lower second feed roller and
are both rollers tuning normally?
4
I
No
I -
Is the semnd feed sector gear turning normally?
Yes
I I
No
I
L
Check the clearance between the second feed sector
1
gear stopper and the stopper pin, (See page 5-47,)
I
Is the one-way clutch on the lower semnd feed roller shaft slip-
ping? (Paper jams frequently at high printing speeds.)
L
Yes
Lightly sand the roller shaft surface with fine
sandpaper (increases the coefficient of friction)
and replace the clutch.
I Is the paper detecting pin moving normally? I
1
~
Adjust the position of the paper detecting pin. (See page 5-54.)
I
Is any paper stuck between the second guide plates? I
No
L
Yes
Remove the paper.
I Are the second guide plates at the correct height? I
No
~
Adjust the height of the plates, (See page 5-43,)
7-13