Ricoh C211 Service Manual page 515

8. Setting Ink
(1)
(2)
(3)
(4)
Open the front door and lower the
ink cartridge holder.
Remove the cap of an ink cartridge.
Insert the ink cartridge into the ink
holder (spout should be facing
lower left hand corner) and set
the ink holder to the original position.
Close the front door.
9. Idling
(1) Press the Reset key on the opera-
tion panel while pressing the "O" key
-----950.
Press the Idling key -----830.
(2) If ~ + D blink on the operation
panel, operate the above procedure
again.
10. Test Print
(1)
(2)
(3)
Set the original face down on the
original table.
Adjust the original guide to match
the original size.
Use the Number
number of prints
Master Making key
830).
keys to set the
and press the
(950) (Start key:
Note:
In the case of a new machine,
the master paper misfeed in-
dicator 8$ + F will blink be-
cause a master is not wrap-
ped around the drum yet.
Press the Reset key, then
press the Master Making key
(950) (Start key: 830).
(4) After one sheet of paper
is
deli-
vered, make a print at the lowest
print speed (1) until the print image
density does not change using a
test chart.
(5) Check the copy image after about
one hundred prints.
1
---——
a—
_ _——— _
3-9