Ricoh C211 Service Manual page 500

2. Exit Pawl Drive Mechanism
[H]
/
The exit pawI
paper. As the
from the drum.
[A] located in the center of the
master clamper [H] approaches
[b]
[F]
drum, guides the center of the printing
the exit pawl, the exit pawl moves away
When the bearing of the pressure ON/OFF cam [C] comes to the top of the pressure
cam [G], the exit pawl drive cam [B], mounted on the pressure ON/OFF cam [C], moves
up. The exit pawl lever [D] then turns clockwise along the surface of the exit pawl drive
cam [B]. Therefore, the exit pawl [A] also comes near the drum until the stopper [F]
contacts the adjusting
screw [E]. This keeps a small clearance between the exit pawl and
the drum surface to enable the printing paper to feed to the vacuum unit.
As the press roller moves away from the drum, the exit pawl drive cam [B] moves down
and the exit pawl lever [D] turns counterclockwise.
This causes, the exit pawl [A] to
separate from the drum.
The exit pawl [A] is held away from the drum when printing pressure is not applied.
2-87
. .