Ricoh C211 Service Manual page 312

-
If you wish to verify that the page size selection is correct, you can
select "Diagnostic Status Page." This file will generate a one page
print-out of PostScript font samples as well as a listing of the current
Controller settings at the bottom of the page. See Appendix A for an
example of this Diagnostic Status Page output.
-
If you have more than one Controller installed on an AppleTalk
network, you will need to add a number to its name so that Appletalk
can distinguish between the Controller units. The file names are
"Priport #1", "Priport #2", "Priport #3", etc. If you only have one
Controller installed on the AppleTalk network, you will not need to use
these files at all.
-
If you have changed the output page size or the name/number of the
Controller and wish to retain that change as the Controller's power on
default, you will also need to use "Save Config Changes."
Step 1. Insert the Priport Controller Disk in the drive and double click on the
floppy icon to open it.
Step 2. Double click on the Priport Controller folder to open it and then
double click on "DownLoader 5.0.1". (A new window will NOT
appear on the screen but a new smaller menu bar with only three
pull-down menus--File Edit Special --will appear.)
Step 3 .Under the File Menu, the selections available are: Download Font
and Download PostScript File and Quit. Double click on
Download PostScript File . (A dialog box listing the 13 possible file
choices will appear on the screen.)
Step 4. Point and click to select the file which will make the desired
configuration change and click on Open. (While the file is being
sent, AppleTalk will display a printer status report. When the file
has been successfully received by the Controller, the following
message will be displayed "The download was successful".)
Step 5. Click OK. If you wish to make any other changes, start again at
Step. 3. If you are finished making or saving the configuration
changes, select Quit under the File menu.
6.15 APPLICATION SOFTWARE SET-UP
1. Printer Drivers:
Each desktop publishing or word processing application provides printer
drivers for PostScript and PCL-5 compatible printers. Please follow the
instructions supplied with your application software to select the appropriate
printer for the page size you wish to send to the Priport. We have supplied
examples for MS Windows 3.1 and WordPerfect.
VT2105 6-28 FSM