Ricoh C211 Service Manual page 650

9. Table of Defective Electrical Components: SS950
Component Condition Phenomenon
2nd Original Sensor ON condition When the main switch is turned on, the .Jam
(Feeler is indicators "A" + ~ blink and reset is impos-
actuated) sible.
OFF condition The original is fed when the Master Making
(Feeler is not key is pressed, but the jam indicators "A" +
actuated) ~ blink and the original leading edge
damages because the original transport
motor does not turn on.
Original Registra- ON condition After the master paper is ejected, the Jam
tion Sensor (Feeler is indicators "A" + ~ blink.
actuated)
OFF condition The original is fed until the leading edge of
(Feeler is not the original goes 5 cm past the exposure
actuated)
glass, then jam indicators "A" + ~ blink.
Master Eject Switch
ON condition
After the master is ejected and one sheet of
(Feeler is paper (trial print) is delivered, the jam un-
actuated) dicators "F" + ~ blink and reset is impos-
sible.
OFF condition
When the master is being ejected, the jam
(Feeler is not
indicators "F"+"~ blink.
actuated)
Pressure Plate Posi- ON condition The pressure plate does not go up. After
tion Switch
(Feeler is
one sheet of paper (trial print) is delivered,
actuated) the jam indicators "F" + & blink.
OFF condition
After the main switch is turned on, the pres-
(Feeler is not sure plate keeps moving up and down.
actuated)
Full Master Detect-
ON condition
When the master eject box is full, the full
ing Switch (Feeler is master indicators "F" + & do not blink.
actuated)
OFF condition After master ejecting is finished, the in-
(Feeler is not dicators "F" + & blink.
actuated)
Paper Table Lower
ON condition The paper table does not go down.
Limit Sensor
(Interrupted)
OFF condition
When paper feed table goes down, overdrive
(Not interrupted)
and "E02" is displayed.
6-28
Rev. 8/89