Ricoh C211 Service Manual page 115

2. ORIGINAL FEED SECTION
2.1 ORIGINAL FEED BELT TENSION ADJUSTMENT
Purpose: To ensure proper original feed,
1.
2.
3.
4.
5,
6,
Remove the rear cover of the fluorescent lamp (2 screws),
Using a tension gauge, apply a 11 O-gram load at the center of the belt [A],
Make sure that the belt deflects 2 to 3 mm,
If not, loosen the mounting screws [B] of the original feed motor [C] and
adjust belt tension by moving the original feed motor.
Using a tension gauge, apply a 11 O-gram load at the center of the belt [F],
Make sure that the belt deflects 1.1 * 0.2 mm.
If incorrect, loosen the mounting screw [D] and adjust belt tension by moving
the belt tensioner [E].
After adjustment, retighten the mounting screws.
5-3