Ricoh C211 Service Manual page 308

6.12 PRIPORT CONTROLLER CONFIGURATION
1. Factory Settings:
The Controller comes preset with the following factory defaults:
-Input Buffers:
Page Size: US Letter (8-1/2" x 11") for U.S. and Canada
-Mode:
2. Controller Configuration Programs:
Three diskettes have been provided with the Controller: one 5 1/4" and
one 3 1/2" for IBM and compatible computers and one 3 1/2" for Apple
Macintosh computers. Each of these configuration programs allows you
to change the factory settings of the Controller (including the ones listed
above) until the next power down of the Controller or permanently if
desired.
NOTE: See Step 9 on page 6-26 on how to save configuration
changes you have made with an IBM and compatible
computers. See Step 5 on page 6-28 on how to save
configuration changes made with an Apple Macintosh.
6.13 CONFIGURATION OF IBM PC AND COMPATIBLES
The configuration program is menu-driven and has been designed to be very
simple to use. (If you will be changing output page size regularly, you should
copy these files to your hard disk.) When the initial configuration is completed
and saved, you should rarely need to use this program disk.
-
If you have the Controller connected to your IBM PC or compatible
output port labeled LPT1 and you wish to output in PostScript mode
with the default page size listed above , you will not need to use this
program to make any configuration changes from the factory settings.
VT2105
Parallel Inputs - 256 Kb
Serial Inputs - 4 Kb
AppleTalk - Not applicable
A4 (210mm x 297mm) for International
PostScript compatible
6-24 FSM