Ricoh C211 Service Manual page 562

3. Adjusting The Right and Left Cutter Switches
Purpose :
To ensure that the cutter slider stops properly.
Method : 1.
2.
3.
4,
Remove the cutter unit
Remove the cutter unit cover.
After moving the cutter slider [A] fully to the left, make sure that the left
cutter switch [B] is turned on and that the switch stroke [C] is 0.1 to 0.5
mm. Also, make sure that the right cutter switch [D] is actuated in the
same fashion.
If incorrect, loosen the mounting screws [E] and adjust the switch posi-
tion.
5-23