Ricoh C211 Service Manual page 549

5. Original Feed
Rollers/ pull-out Rollers:
[cl
1) Remove the original table.
2) Replace the pull-out rollers [A] (1 snap ring, 1 pin).
3) Remove the E-rings at the both end original feed roller shaft [B].
4) Remove the ADF drive gear [C] and bushing (Front).
5) Remove the original feed roller assembly [D].
6) Remove the stopper [E] (hexagonal screw).
7) Replace the original feed rollers [F].
Note:
A one way cutch is installed in the feed roller. Confirm that the
roller can rotate in the arrow direction as shown in the above ii-
Iustration.
5-10