Ricoh C211 Service Manual page 514

6. Setting Paper
(1) Open the paper feed table.
(2) Stack the paper neatly on the paper
feed table.
(3) Bring the paper feed side plates
lightly in contact with the paper.
(4)
Position the paper delivery table for
the printing paper size, using the
scale on the table.
(5) Position the paper delivery side
plate for the printing paper size,
using the scale on the table.
7. Setting a Master Roll
(1) While moving up the release lever,
slide the scanner unit to the left.
(2) Place both spools into a master roll.
(3) Set the master roll in the machine.
(Note: The glossy side is face down).
(4) Set the pressure release lever to the
original position.
(5) Plug in the power cord and turn on
the main switch.
(6) Press the Master Cut button.
(7) Remove the cut master paper.
Note: Check that the master paper
is not folded or creased. '
J
I 1
(8) Close the scanner unit.
3-8