Ricoh C211 Service Manual page 675

CUSTOMER SERVICE GROUP
BULLETIN NUMBER:
APPLICABLE MODEL: VT2105/2200
SUBJECT: MASTER EJECT BELT MODIFICATION
SYMPTOM:
Master eject jams occur frequently. In the worst case, the upper and lower master eject belts slip off the
rollers.
CAUSE:
During March 1996 production, the vendor that produced the master eject belts was changed. The part
numbers were not changed because there was no change in configuration. However, recently it was fou nd
that the new style master eject belts tend to stretch causing the above mentioned symptom.
SOLUTION:
The vendor has again been changed. The part numbers have been changed as follows:
OLD NEW
PART PART
NUMBER NUMBER
C2003545 C2193605 Upper Belt
C2003546 C2193606 Lower Belt
C2193545 C2193605 Upper Belt
C2193546 C2193606 Lower Belt
UNITS AFFECTED:
All VT2105/2200 Priports manufactured after Serial Number C321604XXXX and C340604XXXX respectively
will have the new style Master Eject Belts installed during production.
INTERCHANGEABILITY CHART:
OLD and NEW parts can be used in both OLD and
0
NEW machines.
NEW parts can be used in OLD and NEW machines.
1
OLD parts CAN NOT be used in NEW machines.
Must be installed as a set on units manufactured prior to the S/N cut-in. On units manufactured aft er the S/N cut-in or
3/S
previously modified, use the new part numbers individually.
TECHNICAL SERVICE BULLETIN
VT2105/2200 - 007 REISSUE
DESCRIPTION
VT2105
QTY INT
PAGE
4 4 1 63
4 4 1 63
4 4 1 -
4 4 1 -
NEW parts CAN NOT be used in OLD machines.
2
OLD parts can be used in OLD and NEW machines.
OLD parts CAN NOT be used in NEW machines.
3
NEW parts CAN NOT be used in OLD machines.
11/08/96
REFERENCE
MODEL
VT2200
ITEM PAGE ITEM
9 - -
7 - -
- 59 28
- 59 29