Ricoh C211 Service Manual page 158

7.8 PAPER FEED SECTOR
ADJUSTMENT
GEAR STOPPER CLEARANCE
Purpose:
\
To ensure that the paper feed roller starts rotating when the paper
feed solenoid turns on and stops rotating when the paper feed
solenoid turns off,
1.
2,
3.
4.
5.
6.
Remove the rear cover.
With a spanner (1O mm), gradually turn the shaft [A] counterclockwise,
Make sure that the clearance between the sector pin [B] and the sector
stopper [C] is 0.1 to 0.3 mm after turning the sector gear [D] fully clockwise.
If the clearance is incorrect, loosen the Allen screws [E] and adjust the
clearance by shifting the sector pin [B].
Manually depress the plunger of the paper feed solenoid [F], and make sure
that the clearance between the sector pin [G] and the sector stopper [H] is
0.1 to 0.5 mm.
If the clearance is incorrect, loosen the screws [1]and adjust it by shifting the
paper feed solenoid bracket up or down.
5-46