Ricoh C211 Service Manual page 291

15. Attach the bracket of the Interface harness to the installed Studs [H], use
M4x8 screws with flat washers.
16. Attach the small connector of the Interface Harness to the Video Interface
Board, connector CN101.
17. Re-position the main power cable harness (refer to step 11) and secure
with the removed screw.
18. Snap out the communication port cover plate from the lower center of the
rear cover.
19. Re-assemble the machine.
20. The last installation step is to attach the Ferritecore (not illustrated) onto
the interconnect cable that is used to connect the controller Box to the
Priport. "Snap" the Ferritecore around the cable nearest the MALE end of
the cable (connects to the Priport).
21. Refer to the PCRIP - 10 Priport Controller "Installation Guide" for the
proper cabling configuration.
22. Refer to the PCRIP - 10 Priport Controller "User Guide" for the proper
set-up and operation procedures.
6.4 PART LISTING:
INTERFACE UNIT - 10 TYPE 1 KIT
QUANTITY
1
1
4
2
4
2
1
1
*1
Note: Only the parts that are used in the Model VT2105 are listed.
* Optional Test Tool, Refer to Section 6.6 Step 8.
FSM
DESCRIPTION
Interface Harness with Bracket
Video Interface PCB
Phillips Screws M4x6 with flat washer
Phillips Screws M4x8 with flat washer
Short mounting Studs
Long Mounting Studs
I/O Ribbon Cable
Plastic Sheet
Diagnostic Plug
6-7 VT2105