Table of Contents
Advertisement
Operation
: (To enter Test Pattern Image mode)
1)
Remove the front cover.
2)
Turn off the DIP SW 400-7 (DIP SW 400-8: SS830) on the master processing PCB only
when the power switch is off.
3)
Turn on the main switch.
4)
Press the Image Mode key to select photo mode.
5)
Set the original on the original table.
Caution:
To prevent overheating
of the thermal head, make the original as short as
possible. Any type of original is suitable as the test pattern being used is in
the master processing
PCB memory.
6)
Press the Master Making key (Start key: SS830).
After these operations,
the machine begins master processing
and printing.
If detail confirmation
is required, use facsimile thermal paper instead of master roll and
check the out put with a magnifying glass.
Caution:
To prevent overheating
of the thermal head, do not continuously
operate this
test pattern image mode.
7)
After completion
of the Test Pattern Image mode, turn on DIP SW 400-7 (DIP SW
400-8: SS830).
4-18
Advertisement
Chapters
Table of Contents
