Table of Contents
Advertisement
SERVICE PROGRAM MODE
A program
for checking
electrical
use as follows:
(1/O Check Mode) : SS830
parts is stored in memory. To access the program,
1)
2)
3)
4)
5)
6)
Turn off the power switch.
120V
version:
Turn on the power switch while pressing the Start key, Stop key and Clear key.
This accesses the 1/0 check mode.
Note:
When the 1/0
check
mode is accessed,
only Line mode LED lights and
simultaneously,
1 is displayed in the memory indicator and O is displayed
in the copy counter.
[r] [r]
[rl
O*1
mm
Press the Class key to select either "Input" or "Output".
Memory Indicator"1"
----- Input
Memory Indicator "O" ----- Output
Use the Number keys to enter the proper numbers in the copy counter
(Reference the Service Program Table).
a) When checking
inputs, all of the Image Shift Position indicators
turn on when the
switch or sensor being tested is actuated.
c1
Reset
&
Combine
Idllng
2
Originals
~vl
I%ZB]
Lower
End
Cycle
[T]
[-]
b) When checking the outputs, the component
entered in the counter turns on while
the Start key is pressed.
* Press the Clear key to set the counter number in the copy counter.
After completion
of the Service Program mode, turn off the power switch to clear
the 1/0 check mode.
4-12
Advertisement
Chapters
Table of Contents
