Ricoh C211 Service Manual page 193

10.4 EXIT PAWL TIMING ADJUSTMENT
[B]
I I
Purpose: To ensure that the exit pawl does not contact the master clamper.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Remove the rear cover of the machine.
Press the Image Shifting key to give a maximum white area at the paper
leading edge (image shift position set to "-2").
Stack 20 lb paper on the paper table.
Access l/O Check mode (See page 4-1 1).
. Enter "O"in the memory display and "4" in the copy counter.
Press the Print Start key to raise the paper table to the correct position.
Manually turn on the paper feed and the printing pressure solenoids, Using a
spanner (1O mm), gradually rotate the drum rotation shaft counterclockwise
at a constant speed.
While rotating, make sure that the exit pawl [A] does not contact the master
clamper [B] and that the exit pawl approaches the drum before the leading
edge of the printing paper exits.
If incorrect, loosen the hexagon nut [C] and hexagon bolt [E] and adjust the
exit pawl position by turning the hexagon bolt [D].
Check adjustment by repeating step 7 with the image position shifted to both
maximum forward and maximum backward directions.
5-81