Ricoh C211 Service Manual page 29

6. ELECTRICAL COMPONENT DESCRIPTIONS
NDEX
NAME
FUNCTION Pto P
No.
LOCATION
Motors
4 Original Transport Motor
Transports the original to the scanner A-4
section.
11
Master Feed Motor Feeds the master to the drum.
E-3
16 Cutter Motor
Cut the master.
F-6
19 Master Eject Motor
Sends used master into the master
F-7
eject box.
23 ADF Drive Motor Feeds the original to the scanner
A-4
section.
(VT2300/2500
only)
30 Image shift Motor
Changes the timing between the paper
F-8
feed roller and the drum to adjust
vertical image position.
36
Paper Table Drive Motor Raises and lowers the paper table.
F-5
38 Main Motor Drives paper feed, drum, printing and
F-4
paper delivery unit components.
66 Air Knife Motor
Rotates the fan to separate the paper F-7
leading edge from the drum.
67
Vacuum Motor Provides suction so paper is held firmly
F-5
on the transport belt.
Solenoids
3
Original Pressure Solenoid
Presses the original pressure plate A-4
down on the originals.
(VT2300/2500
only)
20
Master Eject Solenoid Moves the master eject roller to contact
F-6
the drum surface.
26
Master Eject Clamper Opens the master clamp to eject the
F-8
Solenoid master,
28 Master Feed Clamper
Opens the master clamp to clamp the F-8
Solenoid master.
31 Reverse Roller Solenoid Releases the clutch to rotate the
F-6
reverse roller.
35 Paper Feed Solenoid Releases the paper feed sector gear to
F-8
rotate the paper feed roller.
39
Printing Pressure Solenoid Moves the press roller against the drum.
F-8
52
Ink Supply Solenoid Releases the spring clutch to activate
F-7
the ink supply pump.
56 Drum Lock Solenoid
Prevents removal of the drum unit
F-7
unless the drum is at the original stop
position
(This solenoid can be used on the
VT2300/VT2500).
1-16