Ricoh C211 Service Manual page 188

Assembly:
1.
Install the pressure cam drive gear
. . — ——- — —
[A].
NOTE: Make sure that the top part of the pressure cam points to the right [B],
2. Install the relay gear assembly [C].
3. Install the relay belt [D] ~2300/VT2500 only),
4. Install the drive gear [E] (VT2100/VT2130/VT2150 only),
5, Install the lower support
side plate
[F],
6. Adjust the drum drive belt position so that the hexagon bolt [G] can be seen
through the hole in the lower support side plate when the drum drive gear [H]
is at drum home position. (The notch cut in the plate [1]lines up with the gap
between the two teeth [J] on the drum drive gear, Also, the hole [K] in the
drum drive gear lines up with a hole in the rear side plate ~ Check by
inserting a long screwdriver.)
NOTE: These are the only teeth on the drum drive gear that are not backed
by the metal plate on the rear side of the drum drive gear.
5-76