Ricoh C211 Service Manual page 674

CUSTOMER SERVICE GROUP
BULLETIN NUMBER:
APPLICABLE MODEL: VT2105
SUBJECT: MASTER EJECT BELT MODIFICATION
SYMPTOM:
Master eject jams occur frequently. In the worst case, the upper and lower master eject belts slip off the
rollers.
CAUSE:
During March 1996 production, the vendor that produced the master eject belts was changed. The part
numbers were not changed because there was no change in configuration. However, recently it was fou nd
that the new style master eject belts tend to stretch causing the above mentioned symptom.
SOLUTION:
The vendor has again been changed. The part numbers have been changed as follows:
OLD PART NO. NEW PART NO.
C2193545 C2193605
C2193546 C2193606
UNITS AFFECTED:
All VT2105 Priports manufactured after Serial Number C321604XXXX will have the new style Master Ejec t
Belts installed during production.
INTERCHANGEABILITY CHART:
OLD and NEW parts can be used in both OLD and
0
NEW machines.
NEW parts can be used in OLD and NEW machines.
1
OLD parts CAN NOT be used in NEW machines.
Must be installed as a set on units manufactured prior to the S/N cut-in. On units manufactured aft er the S/N cut-in or
3/S
previously modified, use the new part numbers individually.
TECHNICAL SERVICE BULLETIN
VT2105 - 007
DESCRIPTION
Upper Belt
Lower Belt
QTY INT
4 4 1
4 4 1
NEW parts CAN NOT be used in OLD machines.
2
OLD parts can be used in OLD and NEW machines.
OLD parts CAN NOT be used in NEW machines.
3
NEW parts CAN NOT be used in OLD machines.
06/28/96
REFERENCE
PAGE ITEM
63 9
63 7