Ricoh C211 Service Manual page 120

2.6 ORIGINAL
SENSOR
REGISTRATION SENSOR / 2ND ORIGINAL
REPLACEMENT
Original Registration Sensor:
1.
2.
3,
4.
5.
6.
7.
8.
Remove the DF unit stoppers [A] (VT2100/VT2130/VT2150 only).
Remove the exposure glass. (See page 5-6.)
Remove the fluorescent lamp. (See page 5-6.)
Remove the screw securing the stopper [B] (VT2300/VT2500 only).
Remove the guide plate [C] (4 screws),
Disconnect the original registration sensor connector [D],
Remove the sensor with the securing pIate [E] (2 screws),
Remove the original registration sensor [F] from the securing plate.
2nd Original Sensor:
1.-5.
procedures are the same as above.
6.
7.
8.
9.
Remove the original table, (see page 5-2.)
Remove the 2nd original sensor feeler.
Disconnect the 2nd original sensor connector [G],
Remove the 2nd original sensor [H] (2 screws).
5-8