Ricoh C211 Service Manual page 409

ORIGINAL FEED SECTION
1. Overall
[11
[G]
\ .
[E] [B]
[Al
r--+ --+--
-++/
.-
RJ $7&
.::
c
---
c--
--0,
$
.-
+
-----
t
{
!A
A
[K] [L] [H]
[F]
[D] [cl
[J]: 2nd Original Transport Rollers
[K]: Exposure Glass
[L]: Fluorescent Lamp
There are two original feed modes in this model.
ADF Mode : The originals [1] set on the original table are detected by the 1st original
sensor [A]. When the Master Making key (Start key : 830) is pressed, the
original pressure plate [B] presses the originals down. The pull-out roller
[C] starts moving the lowest original forward at the same time. The
lowestoriginal i s separated fromthe otheroriginals by the original f eed
roller [D] and the separation blade [E]. When the 2nd original sensor [F]
detects the original, the 1st original transport rollers [G] start rotating.
The rollers stop after the original activates the original registration sensor
[H]. The 1st original transport rollers start rotating again after the drum
section completes the preparation for the master making.
SADF mode : The separation blade [E] is released in the SADF mode. The original on
the original table is fed to the starting position when the 2nd original sen-
sor [F] detects the original.
2-1