Ricoh C211 Service Manual page 204

3.2 CUTTER HOME POSITION SENSOR REPLACEMENT
/
[B]
/
[F]
1. Remove the tape dispensing assembly. (See steps #1 to #4 on of
2.
3.
5,
6.
" 3.1 CUTTER REPLACEMENT".)
Unhook the cutter spring [A],
Remove the cam drive gear [B]. (1 E-ring)
Remove the pinch roller support bracket [C]. (4 screws)
Remove the cutter home position sensor assembly [D] and replace the
sensor, (1
screw, 1 connector)
Reassemble the tape dispenser.
NOTE: Make sure that the tape dispenser PCB [E] and the tape dispensing
bracket [F] are in lower housing slots [G].
6-6