5.3 RIGHT AND LEFT CUTTER SWITCH ADJUSTMENT
[B]–
.. . . .
. .
1
mm
Purpose: To ensure that the cutter slider stops properly.
1.
2.
2.
4.
5.
Turn off the main switch.
Remove the cutter unit (2 screws).
Remove the cutter unit cover (4 screws).
After moving the cutter slider [A] fully to the left, make sure that the left cutter
switch [B] is turned on and that the switch stroke [C] is 0.1 to 0,5 mm. Also,
make sure that the right cutter switch [D] is actuated in the same fashion.
If incorrect, loosen the mounting screws [E] and adjust the switch position.
5-25