Ricoh C211 Service Manual page 651

9. Table of Defective Electrical Components: SS950
Component Condition Phenomenon
Paper Table Safety
Switch
ON condition
(Feeler is
actuated)
When the main switch is turned on, the cover
open indicator ~ blinks.
OFF condition
(Feeler is not
actuated)
If the paper table lower limit sensor is faulty, the
paper table moves all the way down, locks,
and "E02" is displayed.
Paper Table Height
Sensor
ON condition
(Interrupted)
When the paper feed table goes up, it does
not stop at the proper position and E-02
lights.
OFF condition
(Not interrupted)
The paper feed table does not go up and
when printing starts, jam indicators "B" + ~
blink.
Paper End Sensor ON condition
(Not interrupted)
(Feeler is
actuated)
When there is no paper on the paper feed
table, the Print Start key can be activated,
but jam indicators "B" + ~ blink.
OFF condition
(Not interrupted)
(Feeler is not
actuated)
Though there is paper on the paper table,
Paper End indicators "B" + fi blink.
Pressure Sensor
ON condition
(Interrupted)
After one sheet of paper is printed, the
machine stops. At that time, the counter
does not count down and jam indicator "B"
+ ~ blinks.
OFF condition
(Not interrupted)
When the main switch is on, jam indicators
&
"B" + 0 blink and it cannot be reset.
First Paper Exit
Sensor
ON condition
(Paper exists)
After one sheet of paper is printed, the
machine stops and jam indicators "G" + ~
blink.
i
OFF condition
(Paper does not
exist)
After one sheet of paper is printed, the
machine stops and jam indicators "B" and
&
"E" +
o
blink.
When the main switch is turned on, jam in-
dicators "G" + ~ blink.
After one sheet of paper is printed, the
machine stops and jam indicators "E" + ~
blink.
Second Paper Exit
Sensor
ON condition
(Paper exists)
OFF condition
(Paper does not
exist)
6-29 Rev. 8109