Ricoh C211 Service Manual page 576

2. Adjusting The Paper Table Height
'fid'
z'
\
Purpose : To
Method : 1.
2.
3.
4.
5.
6.
7.
ensure smooth paper feed.
Set the paper feed pressure adjusting lever to the upper position.
Remove the front cover of the m"achine.
Turn on the power switch while pressing the Print Start key (Start key: SS830),
Stop key and Clear key on the operation panel.
. Enter "0" in the memory display and "4"in the copy cOunter.
Press the Print Start key (Start key: SS830) to raise the paper table.
After the paper table stops, insert a scale into the slot at the end of the
paper table. Make sure that the distance between the lower stay [A] and
the upper face of the table is 147.5 to 148.5 mm.
If not, loosen the screw [B] and adjust the position of the actuator [C].
After adjustment, repeat step 5 again by lowering and raising the paper
table several times.
Note:
When mounting the actuator, make sure that the actuator [C]
does not contact the paper table height sensor [D].
5-37