Ricoh C211 Service Manual page 310

PostScript compatible input, Set PCL-5 compatible input,
Enable AppleTalk, Disable AppleTalk, Reset to Factory Config,
Print Test File, Print Diagnostic Status Page, Save
Configuration Changes. You must use this menu to select PCL-5
mode or to re-select PostScript mode if you have previously
selected PCL-5 mode. You may also use items from this menu to
permanently save the configuration settings you have made during
this session, turn AppleTalk on or off, print a test page, print the
diagnostic status page or reset the Controller back to the original
factory settings. Just use the up or down arrow keys to highlight
your choice and <ENTER>.
Step 7. Use the left arrow key to move the highlight back to the "Page"
pull-down menu and <ENTER>.
Size A4, Page Size B4, Page Size B5, US Letter, US Legal. You
must use this menu to select an output page size other than the
factory default. Just use the up or down arrow to highlight your new
output page size and
Step 8. If your computer is connected to the Controller through COM1 or
COM2, OR OR if it is the only computer connected, you may also want
to change the input buffers. The larger the input buffer, the faster
your print job will be processed, however there is a limited amount
of memory to be allocated to input buffers. Use the right arrow key
to move the highlight to " "InputBufrs" pull-down menu and
<ENTER>. The selections available are: Parallel Input Buffer Size <ENTER>.
= 0K, Parallel Input Buffer Size = 256K, Parallel Input Buffer
Size = 256K, Serial Input Buffer Size = 0K and Serial Input
Buffer Size = 64K. If you are the only computer user hooked to the
Controller, you should select the maximum available. For a single
computer connected to COM1 or COM2, use the down arrow key to
select "Serial ... = 64K ". For a single computer connected to LPT1
or LPT2, use the down arrow to choose "Parallel ... = 512K ",
though the factory default of 256K should be adequate.
Step 9. When all the configuration changes are completed, you must decide
if you want to make them permanent. If you do not complete this
step, any changes you have made this session will be lost the next
time the Controller is turned off. If you do complete this step, the
Controller will remember any changes you have made through all
power cycles. Use the right or left arrow to highlight the "Install"
pull-down menu and <ENTER>.
" " Save Configuration Changes " and <ENTER>.
and save the configuration settings of the Controller as often as you
wish.
The two remaining Main Menu items, "File" and "Special", provide functions
which may be useful during setup or reconfiguration of the Controller.
VT2105
<ENTER>.
<ENTER>. The selections available are: Page
<ENTER>. Use the down arrow key to select
6-26
<ENTER>. You can change
FSM