Ricoh C211 Service Manual page 309

-
If you have the Controller connected to your IBM PC or compatible to
an output port labeled LPT2, COM1, or COM2 , or wish to change to
PCL-5 mode, or wish to change to any page size other than the
default page size listed above , you will need to use this program.
-
If you have more than one computer (IBM compatibles and/or a
Macintosh) connected to the Controller, you should be cautious
about switching modes between PostScript and PCL-5
compatibility. To achieve the best output results, both IBM compatibles
should output files in the same mode. Also, if the Controller is set in
PCL-5 mode for the IBM's, the Macintosh will be locked out because it
can only send PostScript compatible files.
Step 1. Insert the Utility Disk in drive A. (If you are copying these files to
your hard disk, first create a subdirectory named PCRIP. At the
DOS prompt type md PCRIP <ENTER>.
<ENTER>. At the C:\PCRIP prompt, type <ENTER>.
and skip to Step 3.)
Step 2. Type A: <ENTER>
Step 3. Type PCRIP <ENTER>
top of the screen.)
File Page Install PC Port Input Bufrs Special Help Quit
The "Help" Menu item explains the general function of each item in
the menu bar. The first item on each of the pull-down menus is
context-sensitive help. This item describes the functions of all the
other items available on whatever pull-down menu you have open.
Step 4. Use the right arrow key to move the highlight over the "PC Port"
pull-down menu and <ENTER> .
Printer Port LPT1, Printer Port LPT2, Printer Port COM1, Printer
Port COM2, Printer Port to LOG file, and Printer Port to NULL.
Step 5. Use the up or down arrow keys to highlight the correct PC output
port and <ENTER>.
the physical port on the back of your computer that is connected by
cable to the Controller. Any selection from any menu will move you
back up to the main menu bar.
If you selected COM1 or COM2, you must select the "PC Port"
pull-down menu again to specify a baud rate. The selections
available are: Com Port Baud Rate 1200, Com Port Baud Rate
2400, Com Port Baud Rate 4800, Com Port Baud Rate 9600 and
Com Port Baud Rate 19.2K . This selection will tell the Controller
what speed to expect data from your computer. Most serial port
users should select "Com Port Baud Rate 19.2K ".
Step 6. Use the left arrow key to move the highlight back to the "Install"
pull-down menu and <ENTER>.
FSM
<ENTER>
<ENTER> (The Main Menu Bar will appear across the
<ENTER> . The selections available are:
<ENTER>. This port selection should match the name of
<ENTER>. The selections available are: Set
<ENTER>. Next, type cd PCRIP
COPY A:*.* <ENTER>
6-25
<ENTER>
VT2105