Ricoh C211 Service Manual page 20

No. Name
16.
17.
18.
19.
20.
21.
22.
23.
24.
25,
26.
27.
28.
Master Cut Button
Pressure Release
Lever
Drum Rotating
Button
Drum Unit
Ink Holder
Main Switch
Small Size Paper
Delivery End Plate
(for smaller than
LT)
Paper Delivery End
Plate (for larger
than LT)
Paper Delivery
Side Plate
Master Eject
Container Cover
Function
Press this button to cut the master paper leading
edge after installing a new master roll,
Use to install the master roll, or to clean the
thermal head.
Press to replace the drum or to remove misfed
paper,
The master paper is wrapped around this unit.
Set the ink cartridge in this holder.
Use to turn the power on or off.
Use to align the leading edge of small-sized (less
than LT) prints,
Use to align the leading edge of prints larger than
LT.
Use to align the prints on the paper delivery table.
Open when removing the master eject container.
Memory/Class switch Use to select memory or class mode,
(VT2300/2500)
Skip Paper Feed Use to adjust paper feed interval or a misted
Switch (VT2300/2500) master.
Printing Density Use to select the printing density according to the
Select Switch
type and quality of the original.
(VT21 00/21 30/21 50)
Master Eject Unit Press to remove misfed paper or a misfed master.
Open Button
1-7