6. MASTER EJECT SECTION
6.1 MASTER EJECT SOLENOID ADJUSTMENT
w
/
o
[A]
—
—
To ensure that master is ejected,
Purpose:
1,
2.
3.
4.
5.
6.
Open the master eject unit and remove the upper cover of the master eject
unit (4 screws),
Access 1/0 check mode. (See page 4-1 1).
.
Enter "O"in the memory
display
and
"7" in the copy counter.
Press the Print Start key to turn on the master eject solenoid,
Confirm that the lower first eject rollers [A] are touched to the drum surface
and also confirm that they are separated from the drum when the master
eject solenoid turns off.
If it is out of adjustment, loosen the screws [B] and adjust the mounting
position of the master eject solenoid [C].
After adjustment, retighten the screws [B].
NOTE:
To easily confirm whether the lower roller touches to the drum surface.
Wrap the drum with the blank paper, Check the paper for roller marks.
5-31