Ricoh C211 Service Manual page 583

8. Adjusting The Clearance
of The Second Feed Roller Sector Stopper
0.1 –
0.3mm
[C]
g
x
['D]
Purpose :
To ensure that the second feed roller starts rotating when the paper feed
solenoid turns on and stops rotating when the paper feed solenoid turns off.
Method :
1. Remove the rear cover (6 screws).
2. With a (lOmm) open end wrench, gradually rotate the shaft (A)
counterclockwise, until the cam follower of the second paper feed sec-
tor gear (B) is at the high lobe of the cam (E).
3.
Make sure that the overthrow clearance between the latching plate (C)
and the sector stopper (D) is 0.1 to 0.3mm.
4.
If the overthrow clearance is incorrect, loosen the two allen screws (F)
and adjust the clearance by shifting the latch plate (C) right to increase
or left to decrease.
5-44
Rev. 8/89