Ricoh C211 Service Manual page 603

5. Adjusting The Master Feed Clamper Cam
Purpose :
Method :
[cl
/
@r
[B]
0N=29 + 0.5mm OFF=less than 25mm
To ensure that the master feed clamper is opened during the master feed
process and is closed during other processes.
1.
2.
3.
4.
5.
Pull out the drum unit and open the master eject unit.
Remove the rear cove" of the machine and turn on the master feed clamper
solenoid [A].
Turn on the solenoid [A] using the following procedure:
Turn on the power switch while pressing the Print Start key (Start key: SS830),
Stop key and Clear key on the operation panel.
Enter "0" in the memory display and "9" in the copy counter.
Press the Print Start key (Start key: SS830) to turn on the master feed clam per
solenoid.
Make sure that the positioning of the cam [B] is 29 & 0.5 mm away from
the bushing as shown above.
If not, loosen the mounting screw [C] and adjust the solenoid position.
Caution: Do not turn on the solenoid any longer than 10 seconds.
After adjustment, retighten the mounting screws [C].
5-63