Ricoh C211 Service Manual page 547

3. Original Registration Sensor/ 2nd Original Sensor
[A]
I
[D]
[E]
\
s Original Registration Sensors
1)
2)
3)
4)
5)
6)
7)
8)
<2nd Original Sensor >
Remove the DF unit stoppers [A]. (If equipped)
Remove the exposure glass (2 spring plates).
Remove the fluorescent lamp.
Remove the screws securing the locking arms.
Remove the guide plate [B].
Disconnect the original registration sensor connector [G].
Remove the sensor with the securing plate [F].
Remove the original registration sensor [H] from the securing plate.
6)
7)
8)
9)
1)
– 5) procedures are the same as above.
Remove the original table. (see letter [H] under exterior cover removal section).
Remove the 2nd original sensor feeler.
Disconnect the 2nd original sensor connector [D].
Remove the 2nd original sensor [E].
5-8