Ricoh C211 Service Manual page 462

/
f
r=
After the master
[E]
A]
[D]
[B]
[cl
eject process is finished, the master eject motor [A] turns clock wise,
driving the gear [C] clockwise through the relay gears.
When the pin [B] of the gear [C] turns about 45 degrees,
immediately due to the one-way clutch in the gear [G]
Therefore, the ejected master in the master eject box is
plate [E].
the pressure plate goes down
and the pressure spring [D]
compressed by the pressure
If the full master detecting switch [F] does not turn on when the pressure plate goes
down, this means that the master eject box is filled with ejected masters. In this case, the
"F" and & indicators blink, and the machine stops after a new master is wrapped.
The "F" and ~ indicator cannot be reset until the master box switch is turned OFF and
ON. This is to prevent the full ejected master condition from being reset without remov-
ing the ejected master from the box.
2-50