Ricoh C211 Service Manual page 591

5. Separation Plate/ Lower Separation Roiler
Separation Plate
1) Remove the separation plate [A] with the spring [B] located under the
separation plate [A]g(1 screw).
Lower Separation Rolier
Perform the following procedure after removing the paper feed roHer/upper
separation roller unit.
1) Remove the front plate [C] of the paper feed section (4 screws).
Lift up then pull out horizontally.
2) Remove the spring [D] hooked on the separation lever [E].
3) Remove the separation lever [E].
4) Remove the lower separation roller shaft [F].
5) Remove the lower separation roller [G] (Allen screw).
5-51