Horn; Accessory Socket - Honda SH300 2006 Manual

HORN

INSPECTION
Remove the front upper cover (page 3-9).
Disconnect the horn connectors.
Connect a 12V battery to the horn terminals.
The horn is normal if it sounds when the 12V battery
is connected across the horn terminals.
REMOVAL/INSTALLATION
Remove the front upper cover (page 3-9).
Disconnect the horn connectors.
Remove the bolt and horn.
Installation is in the reverse order of removal.

ACCESSORY SOCKET

INSPECTION
ACCESSORY SOCKET DOES NOT OPERATE
Remove the front upper cover (page 3-9).
Disconnect the accessory socket 2P connector.
Turn the ignition switch "ON" and measure the volt-
age at the accessory socket 2P connector of the wire
harness side.
CONNECTION: Black/Yellow (+) – Green (–)
If the battery voltage appears, the accessory socket
circuit is normal.
Faulty accessory socket.
If the battery voltage does not appear, inspect the
following:
– Open circuit in Black/Yellow wire between the
fuse box and accessory socket
– Open circuit in Green wire
LIGHTS/METERS/SWITCHES
HORN
CONNECTORS
HORN
2P CONNECTOR
(Wire side of male
terminals)
ACCESSORY
SOCKET 2P
CONNECTOR
CONNECTORS
BOLT
G Bl/Y
22-27