Powering On The T640 Router; Verifying The State Of The Routing Matrix - Juniper TX MATRIX Hardware Manual

TX Matrix Hardware Guide

Powering On the T640 Router

Related
Documentation

Verifying the State of the Routing Matrix

Purpose
186
After you have connected the control and switching planes between the T640 router
and the TX Matrix router, power on the T640 router, monitor the boot process, and verify
the connections.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Switch the circuit breakers on one of the power supplies to the on position (
2.
observe the LEDs on the power supply faceplate. If the power supply is correctly
installed and is functioning properly, the
LED blinks momentarily, then lights steadily.
NOTE: After powering off a power supply, wait at least 60 seconds before
turning it back on. After powering on a power supply, wait at least 60
seconds before turning it off.
If the system is completely powered off when you power on the power
supply, the Routing Engine boots as the power supply completes its startup
sequence.
After a power supply is powered on, it can take up to 60 seconds for status
indicators—such as the output status LEDs on the power supply, the
show chassis
craft interface—to indicate that the power supply is functioning normally.
Ignore error indicators that appear during the first 60 seconds.
Repeat Step 2 for the remaining power supply.
3.
On an external management device connected to the console or auxiliary port of the
4.
T640-CIP, monitor the startup process to verify that the system has booted properly.
NOTE: You do not need to reboot the TX Matrix router after the T640 router
has booted.
Overview of Integrating an Offline T640 Router with the TX Matrix Router on page 179
Verifying the State of the Routing Matrix on page 186
After the T640 router has booted, verify the state of the control planes, switching planes,
and interfaces within the routing matrix. The TX Matrix router is now the point of control
for the routing matrix. You configure and manage the routing matrix through the external
management devices connected to the TX Matrix router.
LED lights steadily, and the
DC OK
command display, and messages on the LED display on the
| ), and
CB ON
Copyright © 2010, Juniper Networks, Inc.