4. Disconnect the cable from the console or auxiliary device.
Figure 262: Installing the Console or Auxiliary Port Cable
1
Console port
—
Installing a Management Console or Auxiliary Port Cable
To install a management console or auxiliary device cable:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. If necessary, turn off the power to the console or auxiliary device.
3. Plug one end of a copper cable with RJ-45 connectors into the CONSOLE or AUXILIARY port on the
Control Board in slot CB0. This port connects to the Routing Engine installed into the Control Board
in slot CB0.
4. Attach the other end of the cable to the console or auxiliary device.
5. Plug one end of another copper cable with RJ-45 connectors into the CONSOLE or AUXILIARY port
on CB1. This port connects to the Routing Engine installed into the control in slot CB1.
6. Attach the other end of the cable to the console or auxiliary device.
Replacing a PTX5000 Management Ethernet Cable
IN THIS SECTION
Removing a PTX5000 Management Ethernet Cable | 491
Installing a PTX5000 Management Ethernet Cable | 491
2
Auxiliary port
—
490