Installing A Ptx5000 Ac Psm - Juniper PTX5000 Hardware Manual

5. Place one hand underneath the PSM to support it and slide it completely out of the chassis.
Figure 194: Removing a PSM

Installing a PTX5000 AC PSM

To install an AC PSM:
1. Using both hands, slide the PSM into the chassis until you feel resistance . Each AC PSM weighs
approximately 10.5 lb (4.8 kg).
2. Push the ejector handle toward the PSM, and tighten the captive screw on the PSM.
3. Verify that the AC IN OK LED on the PSM faceplate is lit steadily, indicating that the PSM is receiving
power.
385