Juniper PTX5000 Hardware Manual page 410

7. Using a number 2 Phillips (+) screwdriver, loosen the two captive screws on the metal AC wiring
compartment of the replacement PDU. Open the metal door of the metal AC wiring compartment.
8. Gently push the wires of the AC power cord into the area for the metal retaining bracket, and pull
the wires to the left toward the metal AC wiring compartment.
9. Using a number 2 Phillips (+) screwdriver, use the four captive screws on the metal retaining bracket
to secure the AC power cord to the PDU. See
Figure 201: Connecting the Metal Retaining Bracket and AC Power Cord to the High Capacity
Delta PDU
10. Connect the wires to the AC terminal block on the High Capacity Delta AC PDU
page 393). Using a 1/5-in. (5.5-mm) slotted screwdriver, loosen the input terminal screws and the
grounding point screw, insert each wire into the grounding point or input terminal, and tighten the
screws.
a. Insert the wire labeled GND into the grounding point.
b. Insert the wire labeled L1 into the L1 input terminal.
c. Insert the wire labeled L2 into the L2 input terminal.
Figure 201 on page 392.
(Figure 202 on
392