Installing A Ptx5000 High Capacity Wye Ac Pdu - Juniper PTX5000 Hardware Manual

CAUTION: Do not leave a PDU slot empty for more than a short time while the
PTX5000 is operational. For proper airflow, the PDU must remain in the chassis or a
blank panel must be used in an empty slot.
Figure 206: Removing a High Capacity Wye AC PDU

Installing a PTX5000 High Capacity Wye AC PDU

To install a High Capacity Wye AC PDU:
1. Ensure that the voltage across the AC power source is 0 V and that there is no chance that the
voltage might become active during installation.
2. Move the power switch located on the faceplate of the PDU to the standby
(
) position.
398