Installing A Ptx5000 Power Supply Module Air Filter - Juniper PTX5000 Hardware Manual

Packet transport router

Hide thumbs Also See for PTX5000:

Table of Contents

Air filter retaining bracket

Installing a PTX5000 Power Supply Module Air Filter

To install the PSM air filter (see

1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to

one of the ESD points on the chassis.

2. Locate markings on the side of the frame indicating airflow direction.

3. Install the air filter into the door. Note that the correct orientation for airflow direction is through the

perforated door and into the PSMs.

4. Engage the edge nearest the perforated faceplate under the front flange, and slide the air filter

further toward the faceplate.

5. Reinstall the air filter retainer bracket and secure with two screws.

6. Tighten the captive screws to secure the PSM door.

Figure 163: Installing a PSM Door Air Filter

Figure 163 on page

Air filter retaining bracket

Table of Contents