Upgrading The Ptx5000 Host Subsystem - Juniper PTX5000 Hardware Manual

2. Plug one end of a UTP Category 5 Ethernet cable into the HOST/ETHERNET port on the Control
Board . This port connects to the Routing Engine installed into the Control Board.
3. Plug the other end of the cable into the network device.
RELATED DOCUMENTATION
PTX5000 Host Subsystem Description | 116
PTX5000 Routing Engine Description | 117
PTX5000 Routing Engine LEDs | 123
PTX5000 Control Board Description | 131
PTX5000 Control Board LEDs | 135
Routing Engines Supported on PTX Series Routers
Connecting the PTX5000 to a Management Ethernet Device | 276
Connecting the PTX5000 to a Management Console or Auxiliary Device | 275
Troubleshooting the PTX5000 Host Subsystem | 605
Troubleshooting the PTX5000 Routing Engines | 607
Troubleshooting the PTX5000 Control Boards | 611
Prevention of Electrostatic Discharge Damage

Upgrading the PTX5000 Host Subsystem

IN THIS SECTION
Upgrading to the RE-PTX-X8-64G Routing Engine in a Redundant Host Subsystem | 493
Upgrading to the RE-PTX-X8-64G Routing Engine in a Nonredundant Host Subsystem | 499
492