Powering The Ptx5000 On And Off; Powering On The Three-Phase Ac-Powered Ptx5000 - Juniper PTX5000 Hardware Manual

Powering the PTX5000 On and Off

IN THIS SECTION

Powering On the Three-Phase AC-Powered PTX5000 | 291

Powering On the Single-Phase AC-Powered PTX5000 | 292
Powering On the DC Powered PTX5000 with 60-A DC PDUs and 60-A DC PSMs | 294
Powering On the DC Powered PTX5000 with 120-A DC PDUs and 120-A DC PSMs | 296
Powering On the DC-Powered PTX5000 with High Capacity DC PDUs and High Capacity DC PSMs | 298
Powering Off the PTX5000 | 299
Powering On the Three-Phase AC-Powered PTX5000
To power on the AC-powered PTX5000 with three-phase delta AC PDUs or three-phase wye AC PDUs,
and with AC PSMs:
NOTE: After powering off a PDU, you must wait at least 60 seconds before powering it on again.
1. Verify that the power distribution units (PDUs) and power supply modules (PSMs) are fully inserted
in the chassis and that the captive screws on the faceplates are tightened.
2. Verify that an external management device is connected to one of the Routing Engine ports on the
Control Board (AUXILIARY or CONSOLE).
NOTE: The management Ethernet port labeled HOST/ETHERNET on the Control Board is
not available until after the initial software configuration. You can monitor the startup
process during the initial installation using devices connected to the AUXILIARY or
CONSOLE ports.
3. Turn on power to the external management device.
4. Switch on the customer-site circuit breakers to provide voltage to the AC power cords.
5. Verify that the PDUs are receiving power.
291