Installing A Ptx5000 Switch Interface Board - Juniper PTX5000 Hardware Manual

Installing a PTX5000 Switch Interface Board

Each SIB can weigh up to 10.4 lb (4.7 kg). To install a SIB (see
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Place one hand underneath the SIB to support it. With the other hand, hold one of the ejector
handles on the SIB faceplate.
3. Carefully align the sides of the SIB with the guides inside the chassis.
4. Slide the SIB into the chassis, carefully ensuring that it is correctly aligned.
5. Twist the ejector handles clockwise until they stop.
6. Bring the SIB online using one of the following methods:
• Press and hold the ONLINE/OFFLINE button on the SIB faceplate. The green OK LED on the
faceplate begins to blink. Hold the button down until the LED blinks.
• Issue the following CLI command on the PTX5000:
user@host> request chassis sib online slot 0
Figure 274: Installing a SIB
Figure 274 on page 508):
508